Decorative stone should be ideally decorated if it is used. It must be handled by packaging, transportation and storage. 1, the packaging of stone. Stone sheet packaging should be determined according to factors such as quantity and transportation conditions. The packaging form is nothing more than wooden box packaging and straw packaging. For long-distance transportation, this method is generally used. The plates are glossy. Place them in the box lined with moisture-proof paper. Wooden boxes must not be used with other materials. Each box shall be provided with iron waistbands at both ends, and iron wrap angles shall be added to the crosspieces. There are two cases of straw packaging. One is to sew the opposite sides of the board with a diameter of not less than 10 mm in the length and width directions. Do not expose the product and bundle it firmly. Another type of packaging is to bundle the glossy plates with a diameter of not less than 10 mm in a "well" shape, and each bundle should be no less than three. After the board is packaged, it should have the number or name, specification and quantity of the board. The supporting engineering materials shall be numbered according to the drawings on each board. There must be “upâ€, “moisture-proof†and “careful and light†signs on the outside of the package and the packaging rope. The symbols and methods of use shall comply with the provisions of GBl91-73 “Package Storage and Transportation Instructionsâ€. 2. Transportation of decorative stone plates. Handling, loading and unloading must comply with the following regulations: (1) It should be lightly handled during handling, and it is strictly forbidden to fall. When the vertical stacking is placed, the back edge must be grounded first; (2) When the single piece of stone sheet exceeds 0.25m2, it should be handled upright. When a large product is transported with a lifting tool, the force edge must be padded; (3) When the product is packed in a wooden box, it is better to use one lifting box for each lifting. When transporting straw-wrap products, do not pull the straw rope; (4) The loading code should be carried out in accordance with the storage requirements. The transportation requirements are stable and collision is strictly prohibited. 3. Storage of stone plates. Stone panels should be stored indoors and outdoor storage must be covered. When the plate is placed upright, the surface should be opposite, the inclination should not be greater than 15°, the height should be 1.6m, and the bottom and the floor must be made of non-polluting elastic material. When it is not possible to stand upright, the surface should be relatively flat, the ground should be flat and solid, and the interlayer pad points should be on the same vertical line. The height should be 1m. After packaging, the height of the stack is 2m. Decorative stone has stricter requirements on packaging technology, and the packaging is not suitable. The lighter causes the corners to be damaged, and the heavy one may break. Transport is not properly maintained. Increased the number of scrap and defective products. Therefore, we should pay attention to the daily storage. Long Fiberglass Tape Measure,Long Tape Measure with Logo,Open Frame Fiberglass Long Tape HENAN BONTHE MEASURING TOOLS. CO., LTD , https://www.tapemeasurebte.com