Digital force gauge is a force measuring instrument used by many industries every day. The frequency of failures of multi-instruments used will increase everywhere. When a digital push-pull force gauge is faulty and cannot be solved, consumers are required to timely Or contact the manufacturer, do not disassemble. Fault phenomenon the reason Solution Boot does not show The battery is damaged Replacement battery Broken keys Replace button Inappropriate keys Press and hold for more than 3 seconds Rally meter shows the value flashes Rally battery voltage is too low Replacement battery Displayed value does not respond to weight changes Circuit board or sensor is damaged Replace circuit board or sensor Broken sensor wire Replace sensor Poor display repeatability Battery voltage is too low Shut down or replace battery Pulled by objects Stable pull Empty pull display is not "0" Boot warm up time is not enough Preheat 3~5 minutes Rally meter put on the ground for a long time When storing, the tension meter should be left unconnected Large pull error Unloaded before loading Clear before loading Unit of measurement error Determine the unit of measure Use for more than one year Recalibrate, check technical manual Remote control has no effect Remote battery voltage is too low Replace remote control battery Rally meter remote control window is dirty Clean window Digital force gauge data chart Marine Rope,Ship Rope,Boat Rope,Twist Rope Baoying Yiliyuan Rope And Net Co.,Ltd , https://www.ylyropes.com
Use digital push-pull gauge safety tips:
1. The safety factor has been considered when designing, but keep in mind that when using it, do not exceed its maximum pull (Cap.). The maximum pull amount has been marked in the obvious place. The company will not be liable for any damage caused by overloading.
2. Please check the rings, hooks and other parts, cotter pins every three months regularly, and check if the screws are loose, deformed, cracked, etc. If any abnormalities are found, stop using them immediately and return them. Parts to ensure safety.
3. Please avoid using under severe conditions such as strong wind, high temperature, etc., so as not to cause incorrect readings.
4. During the vertical operation, it is forbidden to pull the object over the head and ensure that no one is under the object.
5. Do not disassemble and repair by yourself. In case of problems, please contact the company in time.
6. When the display screen flashes, it indicates that the battery is about to run out. When the screen flashes, it is not charged immediately. After about 2 hours of operation, the power will be automatically turned off. After replacing the new battery, it can be used again.
7. When the object being pulled (tare + net weight) exceeds the maximum pull amount, the subtitle flashes 〖-oL-〗 until the pulling amount returns to normal to ensure safe use of the 30T tension meter.
8. If you have any suggestions for this product, please feel free to advise. 