In order to meet people's decoration needs, there are more and more new materials on the market. For example, like tile adhesive, this is a product that is relatively simple to construct, and its adhesive is relatively good, so it is very popular. Like it. The following Xiao Bian will give you a brief introduction on how long the adhesive-backed brush can be tiled and how to properly use the vitrified tile adhesive. How long can the adhesive brush be tiling? How long can the backing brush be tiling? Currently, the tile adhesive on the market is the kind that can be immediately brushed, and it is also suitable for the back treatment of various hard bricks and stones, and it can also be used to improve the tiles. The bonding strength between the stone and the adhesive material can also effectively solve the problems such as hollowing and falling off of tiles, stone wet plasters. How to correctly use vitrified tile adhesive 1. Mixing of vitrified tile adhesive The correct method is: It must be in accordance with the provided emulsion and powder for it to match ratio, this is also used electric mixer for mixing. It must not be arbitrarily felt to equip it. This is wrong because doing so will also cause unevenness. If you use hand-mixing, you can't mix the ingredients. There is probably a lot of dough. 2, the adhesive paste coating For example, some smaller size vitrified tiles can be used to brush brush, but too thin and dot painting method, this is not enough. 3. If there is too little powder at the ratio, it may cause the application to be too thin and uneven. This is a "masterpiece" where workers can be lazy and can be saved. It can be said that doing so is also greatly reducing the effect of adhesive tape. This method cannot be adopted during construction. 4, if you are using the dot coating method, then only a part of the brick at both ends of the map, this approach is to save material. However, it can be said that this practice is also greatly reduced the role of the unpainted parts are still easy to emptying, but also may increase the destructive power, or even double, appear empty phenomenon. 5. For a tile that has just been coated with a slurry, it must be remembered that it cannot be piled together, nor can it be exposed to sunlight or showers, remembering that it must be placed in the room against the wall. At the same time pay attention to the gasket between the bricks, so as to prevent sticking to each other, but also to facilitate ventilation. 6, apply adhesive Smear adhesive must be full and full of pulp, the middle can not be empty, it will not affect the overall effect. The tile on the vitrified tile must have a brick seam, or it may not be released due to the elasticity of the temperature change. Summary: How long can the backing brush be used for tiling and how to use the vitrified tile adhesive properly? In this regard, the adhesive is a new type of material, so when it is used, the method must be correct. It will not affect the overall effect. Weekender Bags,Weekender Travel Duffel Bag,Foldable Travel Duffel Bag,Waterproof Weekender Travel Duffel Bag Dongguan C.Y. RedApple Industrial Limited , https://www.hpgbags.com
