There are handles on the doors of most departments. It exists to make it easier for us to open and close the doors. Because of the high frequency of use, the occurrence of loose breaks is also a relatively common phenomenon. Well, today Xiaobian took everyone together to understand how the security door handle broke . First, how to change the security door handle broken 1, first remove the old door handle, the security door handle is removed from the inside of the room, because the two screws to fix the handle on the inside, as long as the screws are removed on it. 2, when the demolition is very simple, first open the door, and then press the outside with four fingers, press the inside of the thumb (can also help you press this point outside), with a screwdriver to remove the screw. 3, after the screw is removed, slowly take out the handle, and then use the open pliers to open the snap ring on the handle, take out the handle, when doing this step must pay attention to safety, can not hurry to take it slow. 4. Put the new handle on and get the snap ring in place. This time it is basically completed. The remaining step is to put it on the door and put the handle in its original position. 5, when installed must have patience, because there is a screw on the outside of the handle, the screw must be installed on the top, installed firmly, if you feel very expensive, you can find someone to help hold the outside of the handle, You slowly install it inside, as long as it is the one you have, and the other one is ready to be installed. Second, the security door handle installation steps 1. Open the door so that you can operate both internal and external door handles simultaneously. Find the two screws on the inside door handle cover that are fixed together with the inside and outside door handles. 2. Turn the two screws counterclockwise with a Phillips-head screwdriver. The inner door pulls the door handle from the door and pulls the outer door handle away from the door. 3. Remove the two screws with a crosshead screwdriver on the outer edge of the fixed latch door. 4. Insert the inner door handle into the door, use the two fixing screws from the inside of the door, along the hole in the cover, turn the clockwise screw thread to the outer door to pull the glove, tighten the screw, and finally tighten with a Phillips screwdriver . 5. Fix the impact plate and the screws provided with the kit on the curved side door frame around the inner side of the door frame. Editor's summary: The above is a small series of linked security door handle broken how to change and security door handle installation steps introduced, we have to break the security door handle how to change , there should be a more comprehensive understanding of it. Therefore, if you can't find a master to help, you can try to use the above methods to replace and install broken or damaged security door handles. Bolts And Nuts,Nylock Nut,Eye Bolt,Eye Nut Taizhou Fengye Metal Products Co., Ltd. , https://www.fyhandware.com
