High-alumina rhodochrosite refractory bricks are made of selected high-alumina clinker, rhodochrosite, silica nepheline, combined with clay as the main raw materials, molded by high pressure and sintered at high temperature. The products have excellent tensile strength and good thermal shock stability. Clay Bricks for Hot Blast Furnace,Masonry Bricks for High-temperature Fire Escape,Clay Brick for Hot Blast Huixian Xinwei Refractories Co. , https://www.xinweirefractory.com
Chemical magnetic pump features use and installation (Figure)
The main features of chemical magnetic pump: chemical magnetic pump to replace the static seal sealed, so that the pump over-current components in a completely sealed state, completely solve the other pump mechanical seal run, take, drop the shortcomings. Magnetic pump selection of corrosion-resistant, high-strength engineering plastics, steel jade ceramic, stainless steel, etc. as a manufacturing material, so it has good corrosion resistance, and can be transported medium from pollution. Chemical magnetic pump uses: Chemical magnetic pump compact structure, beautiful appearance, small size, low noise, reliable operation, easy to use and maintenance. Can be widely used in chemical, pharmaceutical, petroleum, electroplating, food, film, photographic printing and dyeing, scientific research institutions, national defense and other units pumping acid, lye, oil, rare precious liquid, venom, volatile liquids, and circulating water equipment, Filter supporting. Chemical magnetic pump installation and use: 1. Chemical magnetic pump should be installed horizontally, should not be erected, the plastic pump body can not withstand the weight of the pipeline, the special requirements for vertical installation of the occasion, the motor must be upward. 2. When the suction level above the pump shaft, before opening the suction pipe valve can be opened, if the suction level is lower than the pump shaft, the pipeline should be equipped with the end of the valve. 3. Chemical magnetic pump should be checked before use, the motor blades to be flexible rotation, no stuck and reward sound, the fasteners to be fastened. 4. Check if the motor rotation direction is consistent with the magnetic pump steering mark. 5. After the motor starts, slowly open the discharge valve until the pump into the normal working condition, and then adjust the discharge valve to the desired opening. 6 chemical magnetic pump stopped working, you should close the discharge valve, and then close the suction pipe valve. Chemical magnetic pump Strong and durable pump structure: Chemical magnetic pump drive with active magnet coupling mounted directly on the motor shaft, the pump chamber is completely closed by magnetic coupling indirectly driven pump shaft with a magnet impeller rotation is compact, safe Energy saving. Although the contact liquid part is fluoroplastic, but chemical magnetic pump housing is a metal material, so the pump body enough to withstand the weight of the pipe and withstand mechanical shocks. Chemical magnetic pump use Note: 1. Due to chemical magnetic pump cooling and lubrication is transported by the intermediary shield, it is absolutely forbidden air to run, while avoiding the power outage after the restart caused by the time-space operation. 2 is the transport medium, if it contains solid particles, chemical magnetic pump inlet to add filter: If containing ferromagnetic particles, the need to add magnetic filters. 3. Chemical magnetic pump in use should be less than 40 ℃ ambient temperature, motor temperature rise must not exceed 75 ℃. 4. The media sent by Elm should be in the chemical magnetic pump pump allowed range. Chemical magnetic pump minimum temperature can not be below minus 30 ℃ can not exceed 100 ℃. Conveying the suction pressure is not more than 0.2MPa, the maximum working Zhuangli 1.6MPa, the density is not greater than 1600Kg / m3, the viscosity is not greater than 30X10-6m㎡ / s without hard particles and fibers of the liquid. 5. For the transport fluid is easy to sediment and easy to use media, after use should be promptly cleaned, drain clean chemical magnetic fluid pump. 6. Chemical magnetic pump 1000 hours after normal operation, the bearing should be dismantled and the moving ring end wear and tear, and replace the consumable parts should not be reused. Acid-base magnetic pump This article is provided by Shenzhen Arima Industrial Equipment Co., Ltd. Contact: Mr. Lee