Shandong Dingsheng Refrigeration Equipment Co., Ltd. combined cold storage has many skills in the installation process of refrigeration equipment company. It has mastered the skills, saving time and effort, external appearance and practicality. The following refrigeration engineers introduce the skills of combined cold storage installation. The liquid filling of the Filling Pumps only passes through the hose, does not touch the pump body, and has no valves or seals and other connecting parts. Routine maintenance only requires regular replacement of the hose, which reduces the maintenance cost of the user. Filling Pumps,Liquid Dispensing Filling Pumps,Digital Distribution Filling Pumps,Bottle Filling Smart Dispensing Pump Baoding Chuangrui Precision Pump Co., Ltd. , https://www.crperistalticpump.com
1. Installation of cold storage board:
Refrigeration equipment company library board installation sequence: first install the cold storage floor, then install the side wall station board, the rear wall station board, and the front wall station board, and finally install the cold storage top board. Generally, the library board will have a sequential number, and the joints of the convex and concave parts of the one board will be tightly started to lock the buckles in order. After the library is built, it is completed by sealing the joint between each board with a special sealant.
2. Installation of Kumen:
The installation of the door should first pay attention to the balance of the door frame. If you do not pay attention to the balance of the door frame, it is found that the cold storage door is inclined after the installation. The inclination of the door will directly affect the insulation effect. The specific operation method of the refrigeration equipment company: leave the vertical ridges on the left and right door frame panels out of the height of the door panel on the door, and then use the horizontal balance door frame to fix the door frame, and push the upper door panel of the library door from the bottom to the installation position, and the partition wall Push the door panel up and push it from bottom to top into the mounting position.
3. Installation of refrigeration equipment:
1. The most important thing to install the refrigeration equipment is to fix the equipment. It is very important to fix the equipment for the first time. If the first time is not fixed firmly, the equipment will slowly loosen in the future, and the looseness of the refrigeration equipment will reduce the service life of the equipment. .
2. Refrigeration equipment installation In addition, the distance between the external unit and the internal unit should be selected. The closer the distance is, the better the cooling effect is. The best internal and external machine installation points are selected, and the external machine needs to be covered with rain and sun protection shed.
3. There are two main ways of cooling water system: water pump front type and water pump rear type. When installing the device, the pressure of the water system should be considered. There are three kinds of conditions for the system pressure: when the system stops running, the pump outlet pressure is the system hydrostatic pressure h=Z; when the system is started instantaneously, but the dynamic pressure is not constituted, the pump outlet pressure is the sum of the system hydrostatic pressure and the total pressure of the pump. =Z+HP; When the system is in normal operation, the pump outlet pressure is the sum of the hydrostatic pressure at that point and the static pressure of the pump h=Z+HP-v2/2g. The pressure resistance of the pump housing depends on the way the shaft seal is applied. When the suction side pressure of the pump is above 981 KPa, a mechanical seal is used.
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
Filling Pumps, Available flow rate from 0 to 33000 ml/min,
The Filling Pumps can set the suck-back angle and speed which can reduce the liquid drip when liquid filling.
The Filling Pumps can work with a foot pedal that you can control the pump in a longer distance instead of the traditional way of the start-stop switch.